LN120-200-B Automatic bench for bonding Leonardo 1,2x2,0 mt conveyor. Version with infrared dryer

Our "Leonardo" is the most appropriate solution for automatic spray application of water-based adhesives for bonding over the entire surface of the materials, where it is necessary a high pace of production.

Thanks to its ultra-compact design, spaces are minimized. The suction cabin is equipped with a series of powerful exhausters for the capture and filtering the dust on all sides.

The output of the machine is installed an innovative infrared dryer for fast and efficient drying of the treated materials.

Due to intuitive Touch Screen interface, you can set all the parameters of the machine, the speed of the belt and the spray gun, the width to be covered with adhesive, and much more.

Plus, with the handy kit, for  the replace of the carpet and the front and side filter cells are needed only ten minutes.

If you have not found what you're looking for or you would like more info, contact our staff!

Photogallery

  • LN120-200-C Automation for bonding Leonardo with conveyor belt  from 1,2x2.0 mt. Infrared
  • LN120-200-B Automation for bonding Leonardo with conveyor belt  from 1,2x2.0 mt. Infrared
  • Data Sheet LN120-200-B
  • Scheda tecnica LN120-200-B

The individual components or related products catalog

LN120-200-A Automation for bonding Leonardo with conveyor belt  from 1,2x2.0 mt. Basic version

LN120-200-A: Automatic bench for bonding Leonardo with 1,2x2,0 mt conveyor. Base Version

Our "Leonardo" is the most appropriate solution for automatic spray application of water-based adhesives for bonding over the entire surface of the materials, where it is...
IRS-LN DETAIL IN FUNCTION INFRARED DRYING TUNNEL

IRS-LN: Infrared drying tunnel for automatic machine Leonardo.

Innovative infrared drying tunnel.  Special Thanks to infrared technology, the drying of the treated materials is made with the highest yield, in fact, the short-wave inf...
Spray gun for large bonding

SGL-M Manual Spray Gun for Bonding on Large Surfaces. Manual version.

This spray gun designed for bonding of large surfaces allow to cover an area of 30cm wide with a single run. Thanks to this "blade" of adhesive, coating the entire surfac...
TK8 - Pressure tank for water-based adhesives from 8.5 lt

TK8 - Pressure tank for water-based adhesives from 8.5 lt

This industrial pressure tank, to be connected to one of our spray guns is ideal for the containment of the adhesive to be used. The steel tank with internal Teflon coated, guarant...

Videogallery